My first build using acrylic tube instead of PETG, this build has a lot of extensive case mods to get everything to fit inside the Phanteks Evolv X case, bottom plate took a lot of work allowing for ventilation so that the THOR PSU could go up the right way, I also had to extend the cut out for the PSU window to accomodate 1200W PSU, tried the best I could to try and make everything as clean as possible without having acces to a proper workshop. Changed the orentation of the pump/res combo so that the return and feed line were on the same plane as it was not easy to fill and get the air out the way I originally had it. Also added 7mm offset fittings to the Phanteks distro plate for the graphics card block to make it look a bit cleaner, original offset bends worked OK but I didn't like the look of them.