This was my first custom cooling loop and It was a lot of fun and a bit of challenge to put together. Most of the cooling parts are from XSPC with an SPC pump from EK and the GPU block from EVGA. I had an SSD plate from V1 Tech lying around so I thought it would look good in the corner of the case hiding my drain port. The pump/res is mounted using a bracket I custom designed and 3D printed so that I could mount anything with a 120 mm form factor to the middle of the two front fans with a little bit of play. The custom cables were made by me for a previous build using parts from Ensourced and ModMyMod. I would highly recommend using the shorty cable for the motherboard 24-pin from Ensourced if you want to try custom cables for yourself!