Most of the core components, without the fans and/or any of the water cooling stuff.
First batch of water cooling items has arrived.
All of the things that I’ve currently received, with the Caselabs S8 case, albeit with panels off.
Everything in my possession, as of 2/14, just like last picture - just from a different angle.
Fans and fan RGB frames have arrived. At what point can I get a Phanteks sponsorship?
The Aquacomputer components (2 x Leakshield, 2 x D5 Next RGB) have finally arrived after being stuck at USPS Chicago International sorting center for like a week.
The GPU water block has arrived. It’s very heavy - I’m glad that GPU sag isn’t possible in my build.
37 Bitspower 3/8 x 5/8 compression fittings, 10 Bitspower stop fittings. I have not bought any angles yet. Pass through fittings are inbound.
Radiators and most fans are mounted.
Radiators and most fans are mounted.
Radiators and most fans are mounted.
Radiators and most fans are mounted.
Radiators and most fans are mounted.
Radiators and most fans are mounted.
Radiators and most fans are mounted.
Another shipment of stuff. Two Aquacomputer filters, 120mm adapters for the filters, and two more bottles of clear Koolance 702.
More stuff has arrived - which was necessitated because of limitations in space inside the case (which means - I should’ve planned better). This is two Heatkiller D5 tops, two Heatkiller 100 Tubes (standalone bottoms), and a ton of different mounting options (140/120mm flex mounts for reservoirs, 140/120mm mounts for D5 tops).
Everything is complete, aside from tubing, cable management and water blocking the 4090FE.
Everything is complete, aside from tubing, cable management and water blocking the 4090FE.
Everything is complete, aside from tubing, cable management and water blocking the 4090FE.
There’s no way I’m going to be able to fit these in the case, especially 4 of them. QD4T, 3/8 BSPP to 1/4 BSPP adapter, 1/4 Female to Female adapter, 3/8x5/8 fitting (all on each side).
Tubing done. It was extremely difficult to get the side 360mm in with tubing in place as I’m not going to be able to reach in there after the rad is attached to case.
Assembly is done. Still need to do the bios update and windows installation, but the hardware is assembled.