Was a lot of work to cram all this hardware in such a small case! I wanted push-pull on both radiators so I designed and 3D printed a custom bracket for the rear fan mount that allows me to add the Noctua fan on the exterior of the case. I also had to use a slim Silverstone fan to fit one inside with the aio pump/block so close. The SSD plate is from V1 tech, I'll also note that I asked them to make the logo about half the size as they normally would because I thought it looked better. I also custom made the PSU cables myself using parts from Ensourced and ModMyMod. I would highly recommend using the shorty cable for the motherboard 24-pin from Ensourced if you want to try custom cables for yourself!