Hello everyone from Belarus! This is my second experience with a custom water cooled computer. The previous build was based on the Deepcool Matrex 55 case, which is not very suitable for such cooling. I also made a small post about him, where I asked how best to make a water loop. (https://builds.gg/builds/navy-blue-25081)
I wanted to add a second radiator, but it just wouldn't fit anywhere in height. Therefore, I recently purchased a Lian Li PC-O11 Dynamic (Razer Edition) case and a second 38mm radiator. I really wanted the assembly in white and purple colors, but, unfortunately, Lian Li cases are not sold either in Belarus or in Russia. I was lucky to find a black Razer Edition. Perhaps in a couple of months, I will still repaint it white, but I do not know how to do this, so for now this is only in the plans)
Yes, I know, the tubes from the processor turned out to be a bit crooked: /
After painting the case, the video card will be installed vertically on the Phanteks riser, because the waterblock of my videocard protrudes outside the case and I cannot install the side glass...
Lian Li, why?! This case was originally conceived for such systems and as a result, the water block of a video card does not fit into it(
P.S. The wires from the power supply will also be replaced with white and purple after painting the case)