Back at it again with another completed project. This time, the stakes are higher than a Canadian flag on July 1st.
Project Maple is my entry into the Cooler Master Case mod world series novice modding division.
This was proudly sponsored by Swiftech USA who provided me with pretty much every single piece they sell.

Watercooling:
CPU - Swiftech Apogee SKF Prestige w/Iris ARGB
GPU - Swiftech Komodo 1080ti w/CMWS19 painted backplate.
Pump/Res - (Cut down to 170mm) Swiftech Maelstrom 200mm(170mm) d5 w/Iris ARGB
Radiators - 3x Swiftech Hydrae GT(120/240/360) Painted Tornado red
Compression Fittings - Nanoxia CF 16mm hardline painted
Angled and extension Fittings - Swiftech Dual 45 rotary &15mm
Drain - Dazmode Darkside Pushvalve
Fluid - SwifTech "Mayhem" Dyes in distilled, and 1 drop of Dead Water

Misc:
Fans - Swiftech Helix 120mm w/Iris ARGB
Controllers - Swiftech Iris ARGB Eco Controllers
Cables - Tpbmods created, using Telios Sleeving from Mainframe Customs
Cable Combs - Nanoxia CF with splatter paint job
Paint - BombingScience.Com Ironlak/Moltow/FlameBlue