This is my second build for my girlfriend and for learning how to make custom sleeving.

Inspired by a similar build from TerHorstCustoms, i wanted a small case with two 360 rad with a vertical air flow and.... I found the I100 that can be slighly modified to accept two 360 rad. It is not an SFF build, jsute an mini-ITX. So after cuting a small part of the back tray to put it 15mm up and do two new holes for the middle plate attachment, i could put two 360 slim rad with slim fan. I could put normal fan (25mm) on one rad but i think that should trigger me because i lose the "symetry" of the rads.

I use MDPC-X for all my cable and sleeve, it was a meticulous process and i use the original pin place (i could save some space by doing a custom pin placement but i prefer to not risk it because it was my first try)

With my case modding, the GPU and reservoir are not perfectly straight but it's fine (if you don't look to closely), il will probably redo one bend with a rig do do it right.