Hello Folks,

i want to present you my white custom water cooling build. I used soft tubing but i wanted to look it like hard tubing by avoiding beding it. My favorite for soft tubing is mayhems so i used the tubing in the size of 16 to 10.
It was really hard to find a good white mainboard and as i had bad experience with asus i was a bit nervous when i built my pc. Allready one 5v rgb connector was coming off the mobo. I didnt want to send my mobo to RMA as my build was nearly done. I dont know why i had so bad experience with asus.
Mostly i used alphacool parts in my watercooling parts as for my radiator and fittings. I can really recommend you to buy their products as their prices are really fair.
I had to use the waterblock from bykski for my tuf 7900 xtx as there is no other option. The waterblock from ek is actually about 31cm long so it wouldnt fit in my case.
But as for now i am really happy with this Block as Hotspot is like arround 70 degree when overclocking and base temp about 47 degree. Room temperature is about 26 degree. I used the kryosheet for my 7900 xtx because of the pump out effect on usual thermal paste.

This build really had my nerves as there where things that not worked well. My waterblocking was leaking and bykski send me a new one which worked. At that time i was also on a point to think about to sell All the components. I also bought the ek leak tester so that nothing similar will happen again. In the end i am really happy with my build.

I really hope you like my build and thank you for coming by.