After running into crashes that necessitated dissecting my PC and turning it into a testbench, I finally picked up an Evolv X. The goal was to try and use as many of the parts from my Enthoo 719 as possible since I didn't want to deal with selling anything. This meant using my existing separate reservoir and pump, 2 360mm rads, and 10 fans. The biggest challenge was finding a way to mount and plumb up the pump into the system as the amount of available space was going to be limited by the drive cages and a front radiator. Tube runs aren't perfect, unfortunately I was working with scraps from my prior setup so most tubes I only had 1 shot to get right. The double stacked push/pull fans on the top radiator are a little gratuitous but I kind of dig the look with the unifans edge lighting.